- DSC02480.JPG
- DSC02481.JPG
- DSC02482.JPG
- DSC02483.JPG
- DSC02486.JPG
- DSC02484.JPG
- DSC02485.JPG
- DSC02487.JPG
- SANY5848
Long overdue progress, but now that we have power for our tools, were hooking the motor up to come out again. - Long overdue progress, but now that we have power for our tools, were hooking the motor up to come out again. - SANY5849
Now with the motor out I can finish welding the motor brackets. - Now with the motor out I can finish welding the motor brackets. - SANY5850
For the shift linkage this portion hooks into the Evo bracket ok but is too short for the actuator. We made this to extend the throw. For now we are using a bolt but ultimately it will be a pin with a cotter pin. - For the shift linkage this portion hooks into the Evo bracket ok but is too short for the actuator. We made this to extend the throw. For now we are using a bolt but ultimately it will be a pin with a cotter pin. - SANY5851
For the lower portion we are going to need to modify the bracket and lengthen the post. Here we have bought and cut down a sleeve, drilled a hole through it to fit the stock cotter pin, and welded in a rod to the other end of the sleeve. - For the lower portion we are going to need to modify the bracket and lengthen the post. Here we have bought and cut down a sleeve, drilled a hole through it to fit the stock cotter pin, and welded in a rod to the other end of the sleeve. - SANY5852
Here is the stock bracket, we will be completely removing the rear portion of the bracket by drilling out the rivet and relocating it. - Here is the stock bracket, we will be completely removing the rear portion of the bracket by drilling out the rivet and relocating it. - SANY5854
Here is the new bracket. Man I hate spatter from a flux cored mig welder. - Here is the new bracket. Man I hate spatter from a flux cored mig welder. - SANY5855
Another angle, the z portion of the bracket is welded on the top and bottom and will get extra support. - Another angle, the z portion of the bracket is welded on the top and bottom and will get extra support.