- DSC02015.JPG
Prepping the block by covering all the holes with tape/towel. - Prepping the block by covering all the holes with tape/towel. - DSC02016.JPG
Just made a simple guide so use to mark 3/4" section in the center of the cylinder hole. - Just made a simple guide so use to mark 3/4" section in the center of the cylinder hole. - DSC02017.JPG
- DSC02018.JPG
- DSC02020.JPG
- DSC02006.JPG
And we have clear coat. - And we have clear coat. - DSC02007.JPG
This is me holding the trim section up against the clean part of the door where the trim actually goes. Looks like a pretty good paint match to me. - This is me holding the trim section up against the clean part of the door where the trim actually goes. Looks like a pretty good paint match to me. - DSC02012.JPG
Shiny door handles. - Shiny door handles. - DSC02013.JPG
- DSC02025.JPG
I used a straight die grinder and straight carbide bit, as you can kind of see I was not able to get the aluminum part of the block notched as well. I used some various other grinding bits to finish it off (non-carbide). - I used a straight die grinder and straight carbide bit, as you can kind of see I was not able to get the aluminum part of the block notched as well. I used some various other grinding bits to finish it off (non-carbide). - DSC02026.JPG
- DSC02027.JPG
Finished product before I give it a bath. - Finished product before I give it a bath. - DSC02022.JPG
Eagle H-beam rods. - Eagle H-beam rods. - DSC02024.JPG
A little beefier then stockers. - A little beefier then stockers. - WoWScrnShot_041608_105011.jpg