Place the 12x1.5mm nut over the hole and use a couple smidges of JB weld to hold it in place. I also stuck a rubber grommet through the hole so the JB weld did not seep into the piping. - Place the 12x1.5mm nut over the hole and use a couple smidges of JB weld to hold it in place. I also stuck a rubber grommet through the hole so the JB weld did not seep into the piping.

Created on

Saturday 12 July 2008

Posted on

Saturday 12 July 2008

Albums

• Justin's stuff / 1996 Civic Hatchback / Engine build & turbo / Turbo / b20 IAT sensor install.

Visits

1829