- DSC02514.JPG
Parts: 12x1.5mm nut, b20 IAT sensor ($38 OEM new from Honda), 2 pin plug and wire. - Parts: 12x1.5mm nut, b20 IAT sensor ($38 OEM new from Honda), 2 pin plug and wire. - DSC02516.JPG
Mark the hole for the IAT sensor as close to the throttle body as possible. - Mark the hole for the IAT sensor as close to the throttle body as possible. - DSC02517.JPG
Drill out the hole so the sensor threads just barely fit in the hole. - Drill out the hole so the sensor threads just barely fit in the hole. - DSC02518.JPG
- DSC02519.JPG
I used a wire wheel to remove the powder coating from the area and scuff it up for the JB weld. - I used a wire wheel to remove the powder coating from the area and scuff it up for the JB weld. - DSC02520.JPG
Place the 12x1.5mm nut over the hole and use a couple smidges of JB weld to hold it in place. I also stuck a rubber grommet through the hole so the JB weld did not seep into the piping. - Place the 12x1.5mm nut over the hole and use a couple smidges of JB weld to hold it in place. I also stuck a rubber grommet through the hole so the JB weld did not seep into the piping. - DSC02522.JPG
JB weld of choice. - JB weld of choice. - DSC02523.JPG
Apply JB weld around the whole nut, making sure no air can leak through. - Apply JB weld around the whole nut, making sure no air can leak through. - DSC02524.JPG
Thread in the sensor with some sort of liquid sealer/gasket to make sure no air leaks out. - Thread in the sensor with some sort of liquid sealer/gasket to make sure no air leaks out.