Wiring harnesses, lock controller, mirror switch, lock switch, and window switches.

Window motors and actuators.

Door before any work is done.

Remove the door handle and the release surround.

Remove the plastic retaining screw.

Push on the door surrounding the roller and remove the retaining wire.

The retaining wire.

Reference photo for retaining wire location.

Now use a little muscle and pop and lift the door panel out.

Rear bolt for the window.

Front bolt for the window.

Drivers window removed.

These four bolts need to be removed as well as 2 others located a little farther back to remove the actuator.

Driver manual window actuator removed.

Push on the 4 orange clips in the door to remove the speaker harness from the door. (speaker should be removed for this step.)

Remove the lower steering column shroud to ease the job of pulling the origional door harness through.

Put the door harness through the big hole in your door and connect harness to the inside of the door.

All the Door wiring clips.

Take the harness that goes from the door to the inside of the car and route the clips into the cabin.

Secure the rubber boot inside the fender and connect the 2 harnesses and secure the covering boot.

Run the green clip through the dash and attach it to the power mirror switch and push into place.

All the pretty plastic is now ruined. Cut a new piece from some painters plastic available at a local hardware store and calk it into place.

SANY0478

This is the clip that you will need to run wires from to the passenger door.

This is the standard DX under dash fuse panel.