|
Integra radiator, and throttle cable. - $135, $30
Date: 05/31/2003
Views: 371
|
Old radiator.
Date: 05/31/2003
Views: 306
|
New radiator.
Date: 05/31/2003
Views: 372
|
These are the lower radiator supports for the old radiator. They are spot welded into place.
Date: 05/31/2003
Views: 362
|
These are the would be A/C condenser mounts.
Date: 05/31/2003
Views: 329
|
|
Start by cutting off the A/C supports. I used a dremmel and several cut off wheels.
Date: 05/31/2003
Views: 326
|
Both of the A/C supports have been removed to make way for the double wide radiator.
Date: 05/31/2003
Views: 270
|
Here Im cutting off the little tabs on the upper support.
Date: 05/31/2003
Views: 304
|
Now using a dremmel and cut off wheels I cut arround the spot welds for the radiator supports.
Date: 05/31/2003
Views: 277
|
Both of them have now been removed.
Date: 05/31/2003
Views: 328
|
|
OK Now I put the litle rubber feet on the new radiator and drop it into the position I want. Then I mark on the body where the feet line up.
Date: 05/31/2003
Views: 340
|
Other side.
Date: 05/31/2003
Views: 277
|
Now drill holes into the bottom Supports as shown.
Date: 05/31/2003
Views: 322
|
Using the lower mounts as a template. Line them up into place and drill the holes.
Date: 05/31/2003
Views: 289
|
Other side.
Date: 05/31/2003
Views: 326
|
|
Now using screws, attach the lower supports to the frame. Itll be a tight fit but that means they wont be moving anytime soon.
Date: 05/31/2003
Views: 348
|
Drivers side.
Date: 05/31/2003
Views: 309
|
Now drop the radiator in and check fitment. I should be perfect.
Date: 05/31/2003
Views: 357
|
This Is where Ill mount the drivers side upper support. It has been turned upside down and a section hit with a grinder to fit.
Date: 05/31/2003
Views: 351
|
You can see here where the grinder was used.
Date: 05/31/2003
Views: 344
|
|
Upper support attached.
Date: 05/31/2003
Views: 374
|
The GSR radiator hoses will need to be cut a little bit to fit correctly. Take a bit off both ends on this tube. On the lower tube take about 3/4 to 1 inch of the end that attaches to the radiator.
Date: 05/31/2003
Views: 399
|
Now the radiator fits perfect. I havent put the other upper support in yet. Waiting to get the part on monday.
Date: 05/31/2003
Views: 562
|
Another angle.
Date: 05/31/2003
Views: 869
|
|
