Also, when I have the fan on and try to turn the heat to cold the motor seems like it gets stuck on something and will not stop clicking. This is without the cable attached.
Posted by Guest on Sat 28 Jan 2006 08:57:09 PM EST
More problems. I seem to be getting a lot of noise out of the main relay on the passenger side. Is this normal when i adjust the fan?
Posted by Guest on Sat 28 Jan 2006 08:54:27 PM EST
Great job, I know this took alot of work. Will help me greatly!!.
Posted by Guest on Fri 20 Jan 2006 06:37:50 PM EST
Ya, the frame has got to go! The holes for some of the plastic panels don't line up. What's the deal with that?
Posted by Guest on Mon 16 Jan 2006 08:10:44 PM EST
I will try it with the 96-98 frame. damn! pisses me off.
Posted by Guest on Mon 16 Jan 2006 07:57:57 PM EST
Switching the shell will be pretty close. Only right around the steering wheel its not perfectly centered.
Posted by Guest on Mon 16 Jan 2006 10:54:49 AM EST
I used the dash and frame from a 2000 SI instead of using just the dash and swapping to my frame. Diff part #'s I think thats the prob.
Posted by Guest on Sun 15 Jan 2006 01:58:45 PM EST
Yeah you could do that.
Posted by Guest on Fri 13 Jan 2006 10:29:44 AM EST
yes the black clip connects to the mirrors.
Posted by Guest on Fri 13 Jan 2006 10:29:07 AM EST
Posted by Guest on Fri 13 Jan 2006 10:27:59 AM EST
Posted by Guest on Fri 13 Jan 2006 10:24:56 AM EST
sorry for the slow response. which bolts do you need specs for?
Posted by Guest on Fri 13 Jan 2006 10:23:18 AM EST
ah well there you go. that should help a bit.
Posted by Guest on Fri 13 Jan 2006 10:22:28 AM EST
try hooking power and ground directly to the window motor. if it doesnt work then the motor is shot.
Posted by Guest on Thu 12 Jan 2006 11:47:52 AM EST
i my driver side wouldn't roll up or down.. but passenger side works fine.. i plug everything it place and check all the fuses.. please help
Posted by Guest on Thu 12 Jan 2006 02:30:28 AM EST
I noticed that the bolt/screw that keep the dash on metal frame on both the driver and passenger side were missing.
Posted by Guest on Wed 11 Jan 2006 10:05:19 PM EST
i was wondering if you or anyone reading this could give me on what to torque and how tight???
Posted by Guest on Mon 09 Jan 2006 03:57:57 PM EST
you probably just need to loosen all the bolts and reposition the dash. mine fit like a glove.
Posted by Guest on Mon 09 Jan 2006 11:05:39 AM EST
When I installed the 99-00 dash from a 2000 civic SI the drivers side was not flush with the A-Pillar. Any suggestions or comments?
Posted by Guest on Sun 08 Jan 2006 11:36:06 PM EST
where can i get a cheap manuel on how to spec bolts??....firstname.lastname@example.org
Posted by Guest on Fri 06 Jan 2006 04:02:33 PM EST